About Project
A concrete hotel roof in Marsa Matrouh, waterproofed with polyurea in 2020. Core, part of Hassan Allam Sons, ran the contract. The official record states areas of 1,000 m² and 2,000 m².
Contractor Core, Hassan Allam Sons
Completed 2020
Website Krypton Chemical Solutions — Belle Vue Hotel
Project overview
Marsa Matrouh is Egypt’s Mediterranean edge: wind, salt and a short intense summer. A hotel roof there is both a viewpoint and a lid over guest rooms. The official record states that Belle Vue’s concrete deck was waterproofed with polyurea in 2020, and that salt in the air and a wide temperature swing are the two conditions that roof has to survive.
Scope of waterproofing works
- Place: Belle Vue Hotel, Marsa Matrouh.
- Year: 2020.
- System: polyurea.
- Contractor: Core, Hassan Allam Sons.
- Area: 1,000 m² and 2,000 m².
Krypton systems for this type of work
The official project record names the membrane as Polyurea Rayston, Krypton’s hot-spray pure polyurea. Polyurea Rayston TDS: gel time 4 s at 25°C, typical film 1.5–2 mm from 1.5–2.0 kg/m², elongation 324%, tensile strength 16.2 MPa (EN ISO 527-1/3). The resin is aromatic, so sunlight can shift the colour while mechanical strength remains. An aliphatic topcoat such as Colodur or Impertrans is mentioned on some records only as the usual way to hold appearance, not as a coat confirmed on this job unless the source names it.
Polyurea Rayston TDS: gel time of a 20 g A+B mix is 4 s at 25°C and 3 s at 60°C; tack-free time 30 s at 70°C; typical application 1.5–2.0 kg/m² for a 1.5–2 mm film; maximum elongation 324% and tensile strength 16.2 MPa (EN ISO 527-1/3); tear strength 69 N/mm (ISO 34-1 method B); hardness 87A/35D (ISO 868); liquid water permeability 0.002 kg/m²·h0.5 (EN 1062-3:2008); watertight at 5 bar / 50 m water column (EN 12390-8); static crack bridging class A5 at −10°C and dynamic class B4.2 at 23°C and −20°C (EN 1062-7); impact strength 24.5 N·m, class III (EN ISO 6272-1); adhesion to epoxy-primed concrete 4.0 MPa; substrate pull-off at least 1.4 N/mm² and moisture below 4%; CE marking to EN 1504-2 (0370-CPR-2247); ETA 16/0148; WRAS material approval 2208579.
Surface preparation decides the result
Where the official record discusses application, it follows the Polyurea Rayston TDS: mechanical preparation, cracks repaired first, pull-off at least 1.4 N/mm², concrete moisture below 4%, support temperature 10–40°C. Those are datasheet conditions, not published site-test results for this job.
Contractor: Core, Hassan Allam Sons. Completed: 2020. To discuss a similar project, contact Krypton Egypt.
Official project record: Belle Vue Hotel roof waterproofing on kryptonchemicalsolutions.com.
Project gallery

Explore more work from Krypton Egypt.


No comment