About Project
Capital Business District waterproofing covers foundations, retaining walls, water features, tanks, wet areas and roofs. The official record does not give a year or name an applicator.
Location Capital Business District, New Administrative Capital, Egypt
Website Krypton Chemical Solutions — Capital Business District
Project overview
The district forms the commercial core of Egypt’s New Administrative Capital, east of Cairo. Towers rise above a podium, planted courts and plant rooms. Therefore, much of the waterproofing sits out of sight, under landscaping, behind retaining walls and inside tanks.
Krypton Chemical makes the sprayed resins. However, the project also uses EPDM and a cementitious coating. The official record keeps those systems under their specified names. The Iconic Tower tanks have a separate project page and are not repeated here.
Scope of waterproofing works
- Foundations, retaining walls and water features: EPDM sheet membrane.
- Tanks: hot-sprayed pure polyurea and two-component polyurethane.
- Wet areas: cementitious coating.
- Roofs: polyurea.
- Podium channels: sprayed membrane laid into the deck-edge gutter.
Krypton systems for this type of work
EPDM protects foundations, retaining walls and water features. It is a sheet membrane, laid and jointed. The official page states that it is not the Krypton spray system.
For tanks, the official record names Polyurea Rayston and Impermax 2K. Rayston is hot-sprayed pure polyurea. Impermax 2K is a two-component polyurethane. The record assigns them different duties, so the materials are not interchangeable.
The Rayston data sheet reports watertightness at 5 bar and typical film thickness of 1.5–2 mm. It also lists 324% elongation and 16.2 MPa tensile strength. Impermax 2K requires about 1.8–2.0 kg/m² for a minimum 1.9 mm film. Its data sheet lists 350% elongation and 13 MPa tensile strength. These are product values, not site-test results.
For wet areas, the source names a mineral cementitious coating but no brand. For roofs, it names Polyurea Rayston. It also shows a sprayed membrane in the podium channels.
Surface preparation decides the result
The Rayston data sheet calls for mechanical preparation and crack repair. It specifies pull-off strength of at least 1.4 N/mm², concrete moisture below 4%, and support temperature of 10–40°C.
The source gives spray temperatures for both resins. For Rayston, components A and B run at 65°C and 75°C, with a 65°C hose and at least 140 bar. For Impermax 2K, the listed temperatures are 60°C and 70°C, with the same hose temperature and minimum pressure. In addition, wind above about 25 km/h disrupts Impermax 2K spraying, so crews stop work on an exposed podium. These are application conditions, not published site-test results.
To discuss a similar project, contact Krypton Egypt.
Official project record: Capital Business District waterproofing on kryptonchemicalsolutions.com.
Project Gallery














No comment